Is controlled by my audio interface, right? And Cubase is slave to Sure I’m understanding the word clock correctly – by default this Kemper, and what happens if I forget? Or will my system automatically revert to using the QuantumĢ626’s internal clock as master when I disconnect or power down the Is this all I need to do, or do I need toĬhange any settings in my DAW (Cubase 11) as well?Ĭhange word clock settings each time I connect or disconnect the Options for word clock in my Quantum 2626 control software – it’sĬurrently set to “internal”, so presumably I’d change it to "spdif" if Kemper connected. To be the master clock? If so, where do I need to set this? I can see Thing… I usually work at 48khz, and I see I can set the Kemper to Quantum 2626) I just need a single cable, from Kemper OUT toĪudio-interface IN, and that this needs to be an RCA coaxialĬonnector? I would only need a second cable (from audio interface OUT Understanding that to connect Kemper to audio interface (Presonus Up on both, but bear with me if I’ve made any incorrect These are admittedly blind spots in my knowledge. Used spdif, and never had cause to change word clock settings - so Not new to music computer tech, or audio engineering, I’ve never I’ve read through them all by now… but just wanted to doubleĬheck a few specific/practical things that I’m still not 100% clear And elsewhere, about connecting Kemper via spdif – I think
0 Comments
Leave a Reply. |